How to Do an Oil Change on a Subaru BRZ

The Subaru BRZ is an iconic sports car known for its performance and handling. To keep your Subaru BRZ running smoothly, regular oil changes are essential. Performing an oil change on your Subaru BRZ is a straightforward process that can be done at home with a few basic tools. Follow these simple steps to give your BRZ the care it deserves.

Step 1: Gather the necessary tools and materials

• Oil filter
• Drain pan
• Socket wrench
• New crush washer
• Oil filter wrench
• Oil filter drain tool
• New oil
• Funnel
• Ramps or jack stands
• Oil filter drain tool

Step 2: Prepare your BRZ

Ensure your Subaru BRZ is parked on a level surface and turn off the engine. Engage the parking brake to keep the car securely in place. It's also recommended to let the engine cool down for a while to avoid any potential burning hazards.

Step 3: Lift the car

Using ramps or jack stands, lift the front end of your BRZ. This will provide easier access to the underside of the engine. Make sure the car is properly supported and won't shift during the oil change process.

Step 4: Locate the oil drain plug

Slide underneath your BRZ and locate the oil drain plug. It is typically positioned towards the rear of the engine oil pan. Place your drain pan under the plug to catch the old oil.

Step 5: Drain the oil

Using a socket wrench, carefully loosen the drain plug in a counterclockwise direction. Once loosened, remove the plug and allow the old oil to drain completely into the pan. While the oil is draining, inspect the drain plug for any damage or excessive metal shavings that may require further investigation.

Step 6: Replace the oil filter

Using an oil filter wrench, remove the old oil filter and allow any remaining oil to drain. Take your new oil filter and lubricate the rubber gasket with fresh oil. Install the new filter by hand, tightening until firmly snug.

Step 7: Replace the drain plug

Once the old oil has finished draining, replace the drain plug. In most cases, fitting a new crush washer on the drain plug is recommended to ensure a tight seal and prevent leaks. Tighten the plug with a socket wrench, being careful not to overtighten.

Step 8: Refill with new oil

Using a funnel, pour the appropriate amount and type of new oil into the oil filler cap located on top of the engine. Consult your BRZ owner's manual for the exact oil capacity and recommended oil viscosity. After refilling, replace the oil filler cap securely.

Step 9: Check oil level and start the engine

Remove the dipstick located on the top of the engine and wipe it clean. Insert the dipstick fully and then remove it again to check the oil level. Ensure the oil level is within the appropriate range and add more if necessary. Finally, start the engine and let it run for a few minutes to circulate the new oil.

Step 10: Check for leaks and lower the car

After letting the engine run for a few minutes, check underneath your BRZ for any signs of oil leakage. If everything looks fine, carefully lower the car using ramps or jack stands.

Congratulations! You have successfully completed an oil change on your Subaru BRZ. Regularly performing this maintenance task will help ensure the longevity and optimal performance of your beloved sports car. Remember to dispose of the used oil properly at a designated recycling center.