BMW 725d Long Oil Filter Location

If you are a proud owner of a BMW 725d, it is important to have a basic understanding of its maintenance requirements. Regularly changing the oil filter is a crucial step in ensuring your car's engine stays healthy and performs optimally. In this article, we will guide you on the location of the long oil filter in a BMW 725d.

Why is Changing the Oil Filter Important?

The oil filter plays a vital role in keeping your car's oil clean and free from contaminants. Over time, the filter can become clogged with debris, reducing its effectiveness. This can lead to poor engine performance, reduced fuel efficiency, and potential damage to engine components. Therefore, replacing the oil filter at regular intervals, typically during oil changes, is essential.

Locating the Long Oil Filter

In the BMW 725d, the long oil filter can be found underneath the engine. To access it, you will need to open the hood and locate the engine bay. Once you have done this, follow the steps below:

1. Locate the oil filter housing and cover. It is typically positioned towards the front of the engine compartment, closer to the passenger side.
2. Remove any plastic covers or engine panels obstructing access to the oil filter housing.
3. Using an appropriate tool, rotate the oil filter housing cover counterclockwise to open it.
4. Once the cover is removed, the long oil filter should be visible.

It is important to ensure that the engine is cooled down before attempting to remove the oil filter. Hot oil can cause burns or injury if mishandled. Additionally, it is recommended to wear gloves and have an oil pan or container ready to catch any oil that may spill.

Replacing the Long Oil Filter

With the location of the long oil filter now known, it is relatively straightforward to replace it. Here are the steps:

1. Carefully remove the old oil filter from the housing by pulling it out.
2. Check the housing for any debris or leftover gaskets from the old filter. Clean it if necessary.
3. Apply a thin layer of fresh oil to the rubber gasket of the new oil filter.
4. Insert the new oil filter into the housing, ensuring it is seated correctly.
5. Tighten the oil filter housing cover clockwise until it is secure.
6. Check for any oil leaks around the filter housing.

Remember to consult your BMW 725d owner's manual for specific instructions regarding oil filter replacement and the recommended filter type. Always use genuine or high-quality filters to maintain the performance and longevity of your vehicle.

By following these guidelines, you can easily locate and replace the long oil filter in your BMW 725d. Regularly changing the filter, along with routine oil changes, will contribute to the overall health of your vehicle's engine, ensuring it runs smoothly for years to come.