How to reset Ford Puma tire pressure sensor?

How to Reset Ford Puma Tire Pressure Sensor

How to Reset Ford Puma Tire Pressure Sensor

The tire pressure monitoring system (TPMS) in your Ford Puma is designed to monitor the air pressure in your tires and alert you when it falls below the recommended level. If you've recently adjusted the tire pressure or replaced one or more tires, you may need to reset the TPMS to ensure accurate readings. Follow the steps below to reset the tire pressure sensor in your Ford Puma.

Step 1: Ensure Correct Tire Pressure

Before resetting the tire pressure sensor, make sure all four tires are properly inflated to the recommended pressure specified in your vehicle's owner's manual or the sticker located on the driver's side door jamb.

Step 2: Turn Ignition On

Start by turning the ignition to the "On" position without starting the engine. This will activate the vehicle's electrical system.

Step 3: Locate TPMS Reset Button

Next, locate the TPMS reset button, which is usually located under the steering wheel or in the glove compartment of your Ford Puma. Refer to your vehicle's manual if you're having trouble finding it.

Step 4: Press and Hold TPMS Reset Button

Press and hold the TPMS reset button for approximately three to five seconds until the TPMS indicator light on the dashboard starts blinking. This indicates that the system has entered the TPMS relearn mode.

Step 5: Release the TPMS Reset Button

After the TPMS indicator light starts blinking, release the TPMS reset button. The indicator light will continue flashing for a few more seconds and then turn solid, indicating that the TPMS reset process is complete.

Step 6: Check TPMS Status

To ensure the TPMS has been successfully reset, drive your Ford Puma at a speed above 20 mph (32 km/h) for at least 10 minutes. During this time, the TPMS will recalibrate and should provide accurate readings for each tire's pressure.

Step 7: Verify TPMS Reset

After driving for the specified time, check the TPMS status on the dashboard. If the TPMS indicator light is no longer flashing and remains off, it means the reset process was successful, and the tire pressure sensor has been reset. If the light continues to flash or stays on, there may be an issue with the TPMS system, and it is recommended to have your vehicle inspected by a qualified technician.

Conclusion

Resetting the tire pressure sensor in your Ford Puma is a straightforward process that ensures accurate monitoring of your tire pressure. By following the steps outlined above, you can easily reset the TPMS and maintain optimal safety and performance on the road. Remember, it's crucial to regularly check and maintain the proper tire pressure to ensure a smooth and safe driving experience.

Disclaimer: The information provided in this article is for general informational purposes only. It is always recommended to consult your vehicle's owner's manual or seek assistance from a certified technician for specific instructions related to your Ford Puma model.