How to bleed Kubota M7060 hydraulic system?

How to Bleed a Kubota M7060 Hydraulic System

How to Bleed a Kubota M7060 Hydraulic System

Properly bleeding the hydraulic system of your Kubota M7060 tractor is crucial for maintaining optimal performance and functionality. Air present in the hydraulic fluid can cause various issues, such as reduced hydraulic power and ineffective operation of attachments. In this article, we will guide you through the step-by-step process of bleeding a Kubota M7060 hydraulic system. Follow these instructions carefully to ensure a successful bleed and enhance the productivity of your tractor.

Materials Needed:

• Wrench
• Safety glasses
• Bucket or container
• Kubota-approved hydraulic fluid

Step 1: Prepare the Tractor

Safety is of utmost importance. Before starting any work, park the Kubota M7060 on a level surface and engage the parking brake. Wear safety glasses to protect your eyes from any potential hydraulic fluid splashes.

Step 2: Locate the Bleed Screw

Identify the location of the bleed screw on the Kubota M7060 hydraulic system. It is typically found near the hydraulic pump or control valve. Refer to your tractor's manual for specific details.

Step 3: Prepare the Bleed Container

Place a bucket or container underneath the bleed screw to catch any spilled fluid during the bleeding process. This will prevent any unnecessary mess and help with proper disposal.

Step 4: Open the Bleed Screw

Using a wrench, carefully loosen the bleed screw counterclockwise to open it. Be cautious as the screw may be under pressure, so ensure you are wearing appropriate personal protective equipment to avoid injury.

Step 5: Operate the Hydraulics

Start the Kubota M7060 and operate the hydraulics. Engage the hydraulic system by running the required attachments or functions. Allow the hydraulic fluid to flow through the system for a few minutes to purge any air bubbles.

Step 6: Monitor Fluid Flow

Observe the fluid flow from the bleed screw. Initially, you may notice air bubbles mixed with the fluid. Gradually, the air bubbles should disappear as the hydraulic system gets properly bled. Keep a close eye on the fluid flow and ensure a steady, bubble-free stream.

Step 7: Tighten the Bleed Screw

Once the fluid flows without any air bubbles, carefully tighten the bleed screw clockwise using the wrench. Ensure it is securely closed to prevent any leakage or potential damage to the system.

Step 8: Check Hydraulic Operation

After tightening the bleed screw, test the hydraulic system's functionality. Operate various attachments or functions, ensuring smooth and consistent performance. If the system operates correctly without any irregularities, you have successfully bled the Kubota M7060 hydraulic system.

Step 9: Check Fluid Levels

Finally, check the hydraulic fluid levels and top up if necessary using Kubota-approved hydraulic fluid. Refer to your owner's manual for details on the proper fluid type and filling procedure.

Conclusion

Bleeding the hydraulic system of your Kubota M7060 tractor is vital to maintain its overall performance and efficiency. By following these step-by-step instructions, you can effectively remove any air bubbles and ensure a properly working hydraulic system. Remember to prioritize safety throughout the bleeding process and consult your tractor's manual for specific details or additional guidance.