How to replace iPhone screen glass?

How to Replace iPhone Screen Glass - Step by Step Guide

How to Replace iPhone Screen Glass - Step by Step Guide

Accidents happen, and sometimes your iPhone's screen can crack or shatter. Fortunately, replacing the screen glass of your iPhone is possible and can be done at home. In this step by step guide, we will walk you through the process of replacing the screen glass on your iPhone.

Step 1: Gather the necessary tools

Before you start the replacement process, make sure you have the following tools:

• Replacement screen glass
• Screwdriver set for iPhones
• Suction cup
• Plastic opening tool
• Tweezers
• Adhesive tape
• Microfiber cloth

Step 2: Power off your iPhone

It is crucial to turn off your iPhone fully before attempting any repairs. Press and hold the power button until the "slide to power off" option appears, then slide it to power off your device.

Step 3: Remove the broken screen glass

Start by removing the two screws located at the bottom of your iPhone, on either side of the charging port. Use the screwdriver set to carefully remove the screws and keep them in a safe place.

Next, place the suction cup just above the home button on the front screen. Gently pull up on the suction cup, creating a small gap between the screen and the device's frame. Insert the plastic opening tool into the gap and slowly move it around the edges of the device to loosen the screen adhesive.

Once the adhesive is loosened, carefully lift the screen assembly from the bottom using the suction cup. Hold the screen assembly up at an angle, being cautious not to damage any of the internal cables.

Now, disconnect the three cables connecting the screen assembly to the device's logic board. Use the plastic opening tool or tweezers to carefully lift the connectors and detach them from their sockets.

After removing the broken screen glass, gently clean the exposed area of the device using a microfiber cloth to remove any dust or debris.

Step 4: Install the new screen glass

Take the replacement screen glass and attach the three cables back to their respective sockets on the device's logic board. Ensure they are firmly connected and properly aligned.

Align the top edge of the screen assembly with the top edge of the device and carefully lower it into position. Press down on all sides until it is firmly in place.

Reinsert the two screws at the bottom of the device to secure the screen assembly. Make sure they are tightened but not overly tightened to avoid damaging the threads.

Step 5: Test the new screen

Once the replacement screen glass is installed, power on your iPhone to test its functionality. Check that the touch screen, display, and all other features are working properly.

Step 6: Apply adhesive tape

If your replacement screen glass did not come with adhesive pre-applied, cut adhesive tape to fit the edges of the device's frame. Apply the adhesive tape carefully to ensure it is properly positioned and secure.

Step 7: Final touches

Use a microfiber cloth to clean the screen thoroughly, removing any fingerprints or smudges. This will ensure optimal visibility and a polished look.

Finally, power off your iPhone once again and check if the adhesive tape is firmly holding the screen assembly in place.

Congratulations! You have successfully replaced the screen glass on your iPhone. Enjoy your newly restored device!